CareTech CareIP, User Manual

Page: 21 / 40

21
Programming
Contacts, alarm codes and settings are programmed using a computer and
the CareTech CS2 software or via an automatic download procedure from
icare online.
In some cases, the CareIP can be delivered pre-programmed by the
supplier.
For help with programming, please refer to the service manual or contact
your supplier.
Programming radio triggers
Up to ten radio triggers or other radio-alarm transmitters can be
programmed to CareIP Mobile.
Programming radio transmitters
:
•
Hold down the green button for approximately four seconds until the
unit emits a beep, release the button. The “On” light flashes green.
•
Press the radio trigger. Once the CareIP receives the radio signal, you
will hear a distinct tone signal.
•
Confirm by pressing the red button on the carephone.
Check radio coverage
This should always be done on installation.
•
Hold down the green button for approximately four seconds until the
unit emits a beep, release the button. The “On” light flashes green.
•
Press the radio trigger. The built-in speaker will sound a tone signal
on successful reception. Repeat this in all areas where the alarm
needs to operate.
Functional test
Always check the function after installation and programming. Test alarms
shall be done regularly and in a way that secures the whole alarm chain from
radio transmitter to alarm receiver.