Caretec Tape King, User Manual

Page: 8 / 16

8
To add a current measurement to the memory, press KEY #2 (PLUS-key) and
the respective announcement follows (for example: “5cm and 3mm added to
memory”). Measurement values can be added in memory to enable measuring
of length of up to three million feet (~568 miles). The values in memory are
permanently stored even if Tape King is turned off. Please, make sure to check
the memory prior saving a new value. If necessary delete the memory.
Recall memory: with pressing and holding the KEY #2 (PLUS-key) the
content of the (total) memory will be recalled. (for example: „total value in
memory is 25 m and 10 cm“). If so far no value has been added to the
memory the tape will announce “memory clear”.
Delete memory: to delete the values in the memory, press and hold the
KEY #3 (MINUS-key) until you hear the announcement „memory deleted“.
4.6. CLINOMETER AND SPIRIT LEVEL FUNCTIONS
Tape King includes the functionality of a spirit level and of a clinometer.
Press and hold KEY #4 (MENU-key) to switch to the spirit level and clinometer
functions or select those functions using the voice menu as described in the
section “Voice Menu Functions” in this manual.
The position of Tape King is signalled with tones. If the device is horizontally or
vertically aligned it produces a steady, continuous tone to indicate that the
alignment is perfectly horizontal or vertical. E.g. alignment with the floor (0°),
with the ceiling (180°) or with a wall (+90° or -90°).
Turning the device clockwise or counter-clockwise out of alignment increases
respectively decreases the pitch of the tone and breaks the continuous tone
into a sequence of tones with increasing pauses.
Caution:
Check if the memory already contains measurement
values before you are going to safe a new value.