24
ENG
“EVD mini” +0300036EN - rel. 1.2 - 23.04.2018
The following options are then available:
1.
Directly access the list of parameters saved in EEPROM: select “RS485”;
The operations are performed in real time (ONLINE mode), at the top
right set network address 99 and choose the guided procedure for USB
port recognition, then go to “Device setup”;
Fig. 8.c
2.
Select the model from the range based on the firmware version
and list of configuration parameters (EVDMINI0000E0X_R*.*). These
operations are performed in OFFLINE mode.
Menu
The pages marked 1) can be accessed wither Online or Offline, while
those marked 2) are Online only.
1
2
Fig. 8.d
The operations that can be performed on the pages marked 1) depend
on the first selection made.
Note:
to access the Online help press F1.
Ref.
Description
Home
Select operating mode
Online
o
RS485 (rear
connector)
Offline
o
Device model
Online
Offline
Device setup
Read instant values of
control parameters
Select Load to load a list
of project parameters
(.hex), modify and save a
new project.
Setup summary
Display the default values for the current list of
parameters
Prepare custom setup
See online help.
Update device
Select list of parameters
and then Upload to
controller
-
Upload firmware
Select firmware and
Upload
-
Synoptic and graphs
Overview with position
of probes and probe and
superheat readings in real
time
-
Tab. 8.b
8.4 Restore default parameters
To restore the default parameter values on the controller:
1.
Establish an RS485 serial connection between the computer and the
driver. The LEDs on the USB/RS485 converter will flash;
Fig. 8.e
2.
Select “Update device” and:
a. Click button (A) to open the drop-down menu;
b. Select the list of parameters corresponding to the controller’s
firmware version: “EVDMINI***.hex”;
c. Click “Update” to load the parameters to the list and immediately
after restore the controller parameters to the default value.
C
B
A
Fig. 8.f
3.
Go to “Device setup”: the program automatically reads the default
parameters saved on the controller.
8.5 Setup by direct copy
1.
On the Home page select RS485 (rear connector);
Fig. 8.g
2.
Go to “Device setup”;
Fig. 8.h
