20
7. T R O U B L E S H O O T I N G A N D S P E C I F I C AT I O N
■
TROUBLE SHOOTING
Symptom
Remedy
The scooter will not switch on:
Try recharging the batteries
Check the fuse and circuit breaker in the scooter
The scooter switches on, but
the scooter will not move:
Ensure there is enough power in the batteries; if not,
recharge.
Ensure the freewheel lever is engaged in the ‘DRIVE’
position.
The scooter appears slow:
Check the battery power level and recharge
Check the speed dial is not set to slow.
The seat turns when in
operation:
Slowly rotate the seat until it drops into place and is
secure
The handlebar appears loose:
Tighten the height adjustment handle to secure the
handlebar
Horn sounds involuntarily:
Ensure that the wigwag paddle is released.
Switch the scooter off and on.
Recharge the batteries.
If problem persists contact CareCo.
The LED lights will ‘blink’ if there is a problem with your Titan scooter. The list below will assist
you in identifying any possible malfunction.
1 blink The batteries need charging
2 blinks Check the connections to the motor
3 blinks There is a short circuit to a battery connection.
Contact CareCo Customer Service.
6 blinks The battery charger may still be connected.
Disconnect the charger.
7 blinks Ensure the throttle lever is in the ‘stop’ position.
Switch off for 5 seconds then switch on again.
8 blinks A control system fault is indicated.
Ensure all connections are secure.
10 blinks An excessive voltage has been applied to the control
system. This is usually caused by a poor battery
connection. Check the battery connections.
