Wentwood Fireside Chair
WARNING!
Please read before use:
• The fittings of our fireside chairs should be
tightened every two to three months.
• The chair should not be assembled if any
fittings are missing from the pack.
• Do not sit on the arms.
• Do not use power tools as they can
damage threads.
• To clean the chair wipe down with a damp
cloth using water only.
• Do not put any part of chair in
direct sunlight.
• Do not place near heat.
• To move chair, lift, do not drag as this will
damage chair.
• Maximum user weight of 19 stone.
• Align pins on the back section (1) with the holes on the
rear of the arms of the seat section (2). Insert pins into the
holes but DO NOT push the pins fully in.
• Align holes in the bottom of the back section with the
holes in the seat section and insert bolt (3) tightly using
washers (4) and (5) with the Allen key (6) provided as
shown in image 2.
• If proves difficult to align both pins at the same time then
align one pin on one side and insert the bolt then repeat
for the other.
• Fully tighten the bolts which will pull the back and the
seat sections together tightly.
Assembly Instructions:
Note: It is possible when unpacking this product to
experience a degree of wrinkling on covers. This will
correct itself in the first weeks of use when placed in
an aired room.