Operating Your Scooter
www.careco.co.uk
CareCo, Hubert Road, Brentwood, Essex, CM14 4JE
04
Valour -
Travel Mobility Scooter
Before operation, please remove the Lock Nut and
press circuit breaker button to activate the system.
The rabbit icon indicates fast or high speed. The turtle icon indicates
slow or low speed. By turning this Knob (D) towards chosen icon
you can control overall speed of the scooter.
Horn Button (E)
- Press Horn Button (E) once to sound warning tone when necessary.
Battery Gauge (F)
- The LEDs represent an approximation of battery capacity. If the charge is full, all LEDs
are lit. When only red and orange LEDs are lit, the batteries are consuming and should be charged soon.
When only red LEDs are lit, charge the batteries immediately.
Self Diagnostic Warning Light (G)
- Flashing light indicates there is a problem within scooter. See page 11
for more information.
Throttle (H) (H1)
- Move forward by pulling the right side of Throttle (H) and backward by pulling the left
side of Throttle (H1). (The movement directions can be reversed by local dealers if required.) Release the
throttle to engage the automatic brake. This is also your accelerator, the further you pull it, the faster you
go. (Subject to the position of the Rabbit/Turtle control).
1. Turn the key to the right to turn the scooter on.
2. Turn the key to the left to turn the scooter off.
Speed Dial Knob (D)
Activate Your Scooter
Main Key Switch
Always ensure that the scooter is switched off before getting on or off and before dismantling the scooter.
Turning the scooter OFF whilst driving will bring it to an abrupt stop.
Releasing the throttle engages the automatic brake, but will taxi for a short buffering distance, please keep
safe distance when stopping to prevent any danger.
Before driving the scooter, set the speed to low speed by turning the
knob towards turtle icon.
Drive in high speed when you encounter an up slope, and drive in
low speed when you encounter a down slope.
!
!
!
3
1
2
G
E
F
D
H
C
H1