CareCo Minimus MS01097, User Manual

Page: 24 / 44

24
6. OPERATION
Please follow the steps
1.
Make sure the tiller is raised before reassembling the scooter.
2. Turn key switch to “OFF”.
3.
Place the free wheel mode lever in the drive position.
4.
Take off the basket.
5.
Push the Seat Rotate Lever whilst pulling up on the seat to remove.
6.
Separate the battery cover and remove it from the scooter.
7.
Unfasten the battery Velcro strip and disconnect the battery cable.
8.
Pick up the batteries.
9.
Loosen the tiller adjustment knob and fold down the tiller and re-tighten knob.
10.
Pull the connecting device upward to the rear section and stand upright.
11.
Take off the front section with both hands and lower the shaft.
12.
Reverse upon step while assembly scooter.
No tools are required to disassemble or assemble your scooter.
1. Place the freewheel mode lever in the drive position.
2.
Set the rear section in the up position and make sure the hook for the front
section is connected to the axle of the rear section.
3. Put down the front and rear sections until the scooter is level.
4. Install the battery on the scooter, and make sure it is in the correct position.
5. Set down the seat on the seat post until the swivel lock engages and you hear a
click.
6. Turn key switch to “ON”. Make sure battery gauge indicates sufficient power.
6.3 TRANSPORTING AND LONG-TERM STORAGE THE SCOOTER
WARNING! To avoid personal injury, ask for assistance, if necessary,
while disassembling or assembling your scooter.
Assembling the Scooter