BA06041 - AquaAid Rotating Stool
How to fit:
Adjusting Leg Height:
Rotating Seat:
Additional Precautions:
1. Remove contents from the box.
2. Lay seat upside-down on a flat surface.
Insert each receptacle leg into the bottom
of the seat. Repeat for 3 other legs.
3. Turn the bath stool right-side-up. Attach the
storage tray by placing it between the legs
and inserting the cross braces into the
receptacles on the white leg collars.
1. Before use, adjust height of each leg to your specific needs, making sure all legs are at the same
height. When desired height is reached, lock legs into place by aligning buttons into proper holes.
2. To be sure legs are locked into place, push down on or pull up on the legs.
1. To rotate seat, pull up on handle until seat is free of one of the 12 locked positions and rotate to
desired position. Seat can rotate in both directions.
Note: Built into the seat frame are 12 locking positions which will secure the seat in place to
allow the user to safely stand up from or sit down on the seat. Make sure the seat is in one of
the locked positions before standing or sitting.
1. Inspect all parts for shipping damage before assembly. If there is shipping damage - DO NOT USE.
Contact dealer/carrier for further instructions.
2. Make certain that the height-adjusting snap buttons fully protrude through the same respective
hole of each leg extension. This will ensure that the leg extensions are securely locked in position
and an even height is achieved.
3. Check the rubber tips on the leg extensions for rips, wear or if they are missing. Immediately
replace any or all if any of these imperfections exist.
4. All four leg extensions with rubber tips MUST touch the floor together at all times.
5. DO NOT stand on chair.
NOTE: To maintain the original finish, clean with mild soap and rinse with warm water.
Wipe bath seat dry after each use.
