4
Note!
•
Do not hold the 12V plug on the power
supply while touching the user.
2
Assembly and installation
Check that no parts are damaged. If damage is found, contact Care of Sweden or your local
distributor before using the product. Do not use sharp objects when unpacking as it might damage
the product.
When using an overlay mattress
(CuroCell®
OP10 or CuroCell® CX10):
1a.
Place the overlay
mattress on the base
mattress. Secure the
mattress to the base
using the straps on
the corners of the
mattress.
When using a full replacement mattress
(CuroCell® CX15, CuroCell® CX16 or CuroCell®
CX20):
1b.
Place the mattress
on the bed base.
Secure the mattress to
the bed using the
fastening straps on the
underside of the
mattress.
2.
Hang the control unit on
the foot end of the bed or
place it on a level, steady
surface.
3.
If the mattress is equipped
with a cable holder, place the
power cable in the cable holder by opening
the press studs, placing the cable in the gap
and closing the press studs again. Otherwise,
place the power cable so there is no risk of
stumbling over it, running over it with the bed
wheels, or getting it jammed when raising or
lowering the bed.
4
. Open the lid on the air tube connector
(marked CPR) and connect it to the side of the
control unit.
5
. A click is heard and
felt when correctly
connected. Secure that
both sides of the
connection are closed.
6.
Check that the switch
on the side of the control unit is
set to ’0’ (off). Plug the power
supply into an approved and
easily accessible electrical
socket (100– 240 V).
7.
Check that the power cable
has been correctly connected to
the control unit and that the correct power
supply has been used. (See section 9.1
Technical specification).
The correct P/N is shown on the label on the
power supply. The power supply is part of the
equipment and may not be replaced.
If the control unit has been stored in its
minimum or maximum storage temperature (-
25°C to 70°C), wait at least 1 hour before
starting it. This time is based on an ambient
temperature of 20°C.
Note!
•
Make sure that the mattress is the correct size
for the bed.
•
Make the bed with sheets.
•
If an adjustable bed is used with a full
replacement mattress with fastening straps
(CuroCell CX15, CuroCell CX16 or CuroCell CX20),
the mattress should be fixed only to the moving
parts of bed.
•
Check the cells and press studs to ensure they
are correctly assembled.
•
The mattress should be
used lying in the lengthwise
direction on the mattress,
with feet at the end, market with the feet
symbol.
Summary of Contents for CuroCell A4
Page 34: ...31 Own notes ...
Page 35: ...32 Own notes ...
