3601-M511-O1 Rev C
•
RD2 Series
10
SETUP AND CONFIGURATION, CONT.
data=
(Serial Port Data Bits)
This option allows you to manually select 7 or 8 data bits for the serial port data format.
Note that if Auto-format is enabled (
type=0
), the
data=
setting is ignored.
If the value displayed is acceptable, press the
SETUP
switch again. Otherwise, press the
Up Arrow
switch to toggle to the other value and
then press the
SETUP
switch to save it.
0
= 7 Data bits
1
= 8 Data bits
DISPLAY BRIGHTNESS
The RD2 Remote Display has an extra-bright 2 1/4” LED display. Ten levels of brightness can
be set using the
Up Arrow
and
Right Arrow
switches on the display board.
To Increase Brightness:
1. Press the
Up Arrow
switch.
2. Continue pressing the
Up Arrow
switch to increase the brightness to the desired
level.
To Reduce Brightness:
1. Press the
Right Arrow
switch.
2. Continue pressing the
Right Arrow
switch until the brightness has been reduced to
the desired level.
RE-INSTALLING THE REAR PANEL
After all terminations have been made, changes to setup completed and display brightness set
to the desired level, it’s time to re-install the rear panel.
1. Gently pull any excess cable (AC power and serial) from the enclosure.
2. Securely tighten the cable gland connectors.
!
Do not over-tighten the connectors but make certain they are snug.
!
DO NOT USE TOOLS!
Finger-tighten only!
!
Insure that any unused gland connectors are plugged.
3. Make certain no cables or wires are exposed between the main housing and rear panel
4. Place the rear panel onto the main housing.
5. Secure with the 14 acorn nuts removed earlier.
6. Follow a diagonal pattern when tightening the acorn nuts.
