8525-0358-0M Rev-A
•
DR550C Operation
5
CONFIGURATION
The scale has been pre-configured at the factory and should not require configuration for use
in most applications. In the event that the factory settings do not meet the requirements of
your application, the following describes the steps to configure the scale.
To Begin Configuration:
1.
Press the
ON / OFF
key to turn on the scale.
2.
Press and hold
TARE
key for 6 seconds.
3.
When the display shows
Set
, release the
TARE
key to enter the CONFIGURATION
mode.
4.
The display will change to show
Unit
.
Automatic Shutoff
1.
With the display showing
Unit
, press the
TARE
key.
2.
The display will change to show
AOFF
.
3.
Press the
UNIT
key to begin selection of the automatic shut-off time (in seconds).
4.
The display will change to show
120
.
5.
Press the
TARE
key to toggle through the selections,
120
,
180
,
240
,
300
, or
OFF
.
6.
When the desired time is displayed, press the
UNIT
key.
7.
The display will change to show
AOFF
.
8.
Proceed to “Saving the Settings”.
Saving the Settings
1.
With the display showing
aOff
, press the press
TARE
key.
2.
The display will change to show
End
.
3.
Press the
UNIT
key to save the settings and reset the scale.
4.
Setup is complete.
DISPLAY MESSAGES
DISPLAY MEANING
Lo
Low battery indication
ErrE
E
2
prom Error
ErrL
Zero count low (under 64)
Err
Zero count high (over 32500)
Err
Over Load
