Battery operation
Unplugging the pump from the AC line will automatically put the pump on battery power.
To recharge the battery, plug the pump into an AC wall outlet. The pump will automatically
begin charging. If AC power is interrupted, a built-in rechargeable battery will run the pump.
General instructions
1. Fill or spike feeding container and water bag prior to setting up pump.
2. Turn on pump by pressing
Power
button in lower right-hand corner.
3. To achieve proper accuracy, the fluid line in the feeding set bag must be 6 in.
above the top of the feeding pump when initiating the feeding cycle.
4. Select
}
Keep Setting
s or
}
Clear Settings
.
For day-to-day use with the same feeding regimen, select
}
Keep Settings
.
To place the Kangaroo™ Joey Pump in Intermittent Mode
1. Select
}
More
and then
}
Continuous/Intermittent.
Select
}
Intermittent Mode
and then press
}
Done
.
2. Load the feeding set per diagram on the feeding pump.* Don’t overstretch the tubing.
Priming the pump
1. Press
}
Prime Pump
to access the pump priming options.
2. Press
}
Auto Prime
to automatically prime the pump set. The pump will quickly prime
the feed line and stop the formula before reaching the end of the line.
3. Press and hold
}
Hold to Prime Feed
to prime the feed line down to the connector
at the end of the pump set.
4. Press
}
Done
.
Setting the bolus feed rate
1.
Press
}
Adjust Bolus.
Select
}
Bolus Rate
.
Use the buttons on the left to set the rate from 1 to 400 mL per hour. Press
}
Enter.
2. Select
}
Number of Boluses
.
Use the buttons on the left to set the number of bolus feeds; 99 maximum. Press
}
Enter
.
3. Select
}
Volume per Bolus
.
Use the buttons on the left to set the volume per bolus; 3,000 maximum. Press
}
Enter
.
4. Select
}
Bolus Interval
.
Use the buttons on the left to set the feed interval; 24 maximum. Press
}
Enter
.
5. Press
}
Done
.
Setting the flush interval/rate (option available only if a flushing set is loaded)
1. Select
}
Adjust Bolus
, then
}
Flush Volume
to set the volume of water administered per flush cycle
from 10 to 500 in increments of 1 mL. Press
}
Enter
.
2. Select
}
Flush Interval
to define the time interval between the start of each flushing cycle
from 1 to 24 hours in increments of 1 hour. Press
}
Enter
.
3. Press
}
Done
.
4. Press
}
Run
. A small drop will scroll down the screen when running.
Pump sets should not be reused after 24 hours of initial usage.
Quick Reference Guide: Intermittent operation
Cardinal Health™ Kangaroo™ Joey Enteral Feeding Pump
* For additional operating instructions and information, see the Operating
Manual for the Kangaroo
™
Joey Enteral Feeding Pump “Intermittent Operation.”
© 2020 Cardinal Health. All Rights Reserved. CARDINAL HEALTH, the Cardinal
Health LOGO and KANGAROO are trademarks of Cardinal Health and may
be registered in the US and/or in other countries. All other marks are the
property of their respective owners. Lit. No. 2MS20-1146357 (04/2020)
