Cardinal Health Alaris 8000 Series, Directions For Use Manual

Page: 81 / 378

Programming
2-25 Alaris
®
System Directions for Use
Pump and Syringe Modules Section
CHANNEL
SELECT
CHANNEL
OFF
RESTART
PAUSE
OR
Continuous Infusion (Continued)
CHANNEL
SELECT
CHANNEL
OFF
RESTART
PAUSE
ALARM
INFUSE STANDBY
ALARM
INFUSE STANDBY
CHANNEL
SELECT
CHANNEL
OFF
PAUSE
RESTART
RATE (mL/h)
Pausing and Restarting Infusion
(Continued)
2. To reinitiate infusion:
• Press
RESTART
key.
OR
• Press
CHANNEL SELECT
key and then press
START
soft key.
NOTES:
€
To view additional drugs/concentrations, press a soft key next
to a letter group to navigate through alphabet, and/or
PAGE
UP
and
PAGE DOWN
soft keys.

The facility may choose to to prepopulate standard drug
concentrations, or leave an open entry (_ _ / _ _ mL) and
allow the clinician to enter the desired concentration.
‚
Once a patient weight is entered, for any module, it is
automatically entered for any subsequent weight-based
calculation.
ƒ
Pump Module: At rates less than
10
mL/h, the rate is
displayed to
2
decimal places, and the
VTBI
can be entered
and is displayed to
2
decimal places.
„
Pump Module: In the Drug Calculation mode, the system
infuses at the calculated rate rounded to the nearest one-
hundredth of a mL per hour (as displayed on programming
screen). The rate shown in the Rate Display will be rounded
to the nearest one-tenth of a mL per hour.
The Pump Module keypad is used in the illustrations but the
keys are the same for the Syringe Module.
Restoring Infusion
1. To restart infusion using stored parameters, press
RESTORE
soft key.
2. Verify parameters are valid and press
START
soft key.
Primary Infusion
- With Guardrails
®
Suite MX Protection (Continued)