Cardinal Health Alaris 8000 Series, Directions For Use Manual

Page: 13 / 378

NOTES:
€
Individual hospital/facility may choose to permanently attach
modules. To remove permanently attached modules, contact
qualified service personnel.

Application of adhesive tape or other materials to the sides of
the PC Unit and modules may prevent proper latching.
‚
The Alaris
®
System is designed to operate a maximum of
4
infusion or monitoring modules. The Alaris
®
Auto-ID Module is
not included in the
4
-module total. Modules added in excess
of
4
will not be recognized by the system. The module(s) can
be attached in any position; however, when mounted on an
IV
pole, it is recommended that a balanced configuration be
maintained.
General Setup and Operation
1-3
General Setup and Operation
Attaching and Detaching Module(s)
Alaris
®
System Directions for Use
PC Unit Section
1. Position free module at a
45
° angle, aligning
IUI
connectors.
Modules can be attached to either side of the PC Unit or to
either side of another module. The process to attach or
detach is the same for either side, whether attaching/
detaching to/from a PC Unit or another module.
Attaching Module(s) €  ‚
45°
2. Rotate free module down against PC Unit or attached
module, until release latch snaps in place.
When properly secured/snapped,
the
release latch provides a very
secure connection between
modules. If not properly latched, a
module can be dislodged during
operation.
WARNING
IUI Connectors
Release Latch