www.carcomm.nl
www.carcomm.nl
Carcomm Navigation Cradle
Carcomm Navigation Cradle
© Copyright Carcomm International BV 2006. Subject to change without previous notice.
All used brandnames are owned by their respective owners
CNM-71 Pioneer AVIC S1
CNM-71 Pioneer AVIC S1
Installing the Carcomm Navigation Cradle
Connecting a Pioneer ND-TMC 1 Module
Connecting an External GPS Antenna
1. Mount the window suction mount or Safety-Mount® (sold separately, instructions
included with the product ) To mount the window mount please clean the window and
place the window mount in your preferred position. Tighten the nut on the base of the
mount to make it stick to the window. Place the window mount in a position where it
doesn’t interfere with the operation of the vehicle.
2. You can screw the cradle to your mounting part directly, or use the included swivel.
If you use a Safety-Mount® it may be necessary to drill holes in the Safety-Mount®
to be able to screw on the cradle with or without swivel. You can use the pattern on the
front page to see the positions where to drill the holes in the Safety-Mount®.
Adjust the swivel to optimize your view on the Avic S1 screen and tighten it well.
3. Align the cradle on the rotating swivel or Safety-Mount® and screw the cradle onto it
with the enclosed screws through the 4 holes. Tighten the screws well.
4. Plug the Cigarette jack into the Cigarette plug adaptor, check if the red light of the
cigarette plug is lighted. Now you are able to charge the Avic S1 in the mobile cradle.
5. Disassemble the Cigarette plug or cut it from the wiring loom and strip the wires.
(The cradle is also available with a fuse in the wiring loom instead of cigarette plug.)
6. Now the red wire (with fuse) needs to be connected to the red wire from the cradle
wiring loom. Then the other side of the fuse’s wire needs to be connected to the
vehicle’s 12V Ignition controlled voltage (+15) to avoid draining the vehicle’s battery
when the vehicle is not used for a long time.
The black wire needs to be connected to the Negative Ground of the vehicle.
7. Slide the Avic S1 into the cradle slowly and make sure the Avic S1 is centred
well above the connector. Then press it over the connector gently.
When removing the Avic S1 from the cradle use one hand to hold the cradle and
other hand to pull the Avic S1 out of it.
You can connect the Pioneer ND-TMC 1 module to the cradle
with the supplied adapter. Connect the Pioneer ND-TMC 1 to
the adapter and connect the adapter to the 8 pin DIN connector
that is located on the cable coming from the cradle.
If you have a windscreen with UV coating you could experience bad signal reception.
In that case you can connect a Carcomm External GPS Antenna to the Avic S1
to improve reception. You connect the external antenna directly to the Avic S1. Please
consult the Pioneer Avic S1 manual on how to connect an external GPS antenna to the
navigation unit.
For permanent installation and connection to the cars ignition power move on to step 5.
Move on to step 7.
Step 1
Step 2
Step 3
Step 4
Step 7
2
