Installation Instruction
：
IMPORTANT INSTALLATION NOTES
：
AFTER INSTALLATION,PLEASE CHECK AND TEST:
WARNING:
MAINTENANCE:
Power Selectable SIZE2~SIZE4
Rack & Pinion Door Closer
Door closer SIZE2/3/4 80kg backcheck
Instructions
CDC-1
When adjusting please note there is a MAXIMUM OF 2 TURNS.
Over adjustment will affect the performance of the closer.
In such instance our Guarantee becomes VOID.
6.Adjust length of forearm so that adjustable forearm is
perpendicular to frame when assembled to preloaded
main arm.
7.Secure forearm to main arm with screws provided and
snap pinion cap over shaft at bottom of closer.
Fixing holes
Fixing screw
Link arm
Main arm
1.Open the door leaf to its maximum opening angle and release. The door leaf should close fully into the door frame and overcome the latch.
2.Open the door leaf and rest the latch bolt on the striker plate. Release the door leaf. The door closer should have sufficient power to latch the door leaf closed.
3.Back-check provides a cushioning effect when the door is forcibly thrown open but does not serve as substiture for a door stop.
1.Check the door closer every three months to ensure all fixings are secure and adjust,if necessary,adjust the closing and latching speed and mark the door operating both functionally and smoothly.
1.Due to door closer power sizes 1&2 are NOT considered suitable for use fire/smoke door assemblies. Therefore,the minimum spring strength allowed for fire/smoke door assemblies is spring strength 3.
2.The mechanical hold open devices must NOT be installed in fire/smoke door.
3.Door closer should NOT be opened beyond the max. opening angle of the power size you selected.
4.This door closer contains a powerful spring,which is inserted into the body under pressure. Under circumstances should not attempt to dismantle the door closer.
Arm shoe
3.Install adjustable forearm / arm and assemble to
frame using screws provided.
4.Install main arm to top pinion shaft using screws provided.
5.Mount closer on door using screws provided.
1.According to the information show above.
Select power size to suit door width or weight.
Determine installation position according to the
power strength of closer and use template mark
four(4) holes on door for closer and two(2) holes
on frame for arm shoe.
2.Drill pilot holes in door for #10-13x2" all-purpose
screws or drill and tap for M5xP0.8 machine
screws.
Closer body
6
5
4
3
2
1
NO.1
Standard
90
NO.2
Adjust the Closing & Latching speed.
1.The door closer can control two different speeds.
2.The NO.1 speed-adjusting valve controls Closing speed,
and the NO.2 speed adjusting valve controls the Latching speed.
Back-Check Adjustment
To increase Back-check action turn valve clockwise. To decrease,
or to turn off Back-check action turn valve counter clockwise.
Fixing in Fig1
SIZE2
850mm
40Kg
180
180
130
80Kg
60Kg
950mm
1100mm
Power
size
Max.
Door width
Max.
Door weight
Max.
Door Opening
SIZE3
SIZE4
Carbine Radius
14 John Hines Ave
Minchinbury NSW 2770
www.carbine.com.au
Baber Lock & Key New Zealand
16 Parkhead Pl Albany 0632 NZ
www.baberlocknkey.co.nz
11006 ZINS-H1317-8Z
4
6
2
1
5
3
Back check(OPTIONAL)
NO.1 Closing
NO.2 Latching
2.Apply light oil to arm knuckle joint and door hinges.
