9
Mod. Kronos 70:
one piece of beech wood between 30 and 45 centimetres in length and of a weight of 1 to
1.8 kg.
Mod. Kronos 80:
one piece of beech wood between 40 and 55 centimetres in length and of a weight of
1.25 to 2.1 kg.
Mod. Kronos 100: one piece of beech wood between 45 and 65 centimetres in length and of a weight of 1.6
to 2.5 kg.
- Adjust the primary air inlet to an opening of between 5 and 8 mm.
- Adjust the secondary air inlet to halfway, i.e. at an angle of approximately 90º with the front of the device.
MAINTENANCE
To clean the glass, be careful to spray the cleaning product on a cloth and clean only the glass,
without wetting the rest of the door.
Window-cleaners and special products often contain chemicals that
attack the paint and the ceramic fibre seals and cause oxidation of the metal parts.
It is very important not to wet the woodburner with window-cleaner, water or special cleaning products.
Heatproof paint is not waterproof.
Clean the paintwork with a feather duster or a soft, dry cloth. If over time you want to repaint the insert, the
manufacturer makes a spray paint available from your dealer.
TIPS AND SAFETY STANDARDS
- You should check the chimney regularly and keep it clean and in good condition. Creosote build-up in the
chimney could cause it to catch fire.
- Warn children of the danger of burns.
- Do not modify the appliance without authorisation and use only original spare parts.
- The appliance must be installed on floors with sufficient bearing capacity.
- Observe the minimum safety distances from nearby combustible materials.
In front of the appliance: minimum 1.6 m.
- Combustible materials must not be installed on the appliance or inside the brickwork.
- On days with adverse draught conditions (very low atmospheric pressure, heavy frosts), or when the flue is
very cold, or in chimneys with a poor draught, you can help the draught to start before lighting the fire by
heating the flue:
1. Prepare the wood for lighting inside the woodburner.
2. Place a firelighter or a sheet of newspaper on the deflector at the start of the flue and set fire to it.
3. After a few seconds, when the chimney draught starts, light the wood as instructed.
