Carba-Tec CTJ-381, Instruction Manual

Page: 9 / 16

8
ADJUSTING BELT TENSION
DISCONNECT POWER SOURCE FIRST!!!
Remove the pulley guard Fig. 22 (C) by taking out the 4
fixing screws Fig. 22 (D). Loosen the slotted screws Fig.
23 (E) and lever up the motor by placing a piece of wood
under the motor plate.Retighten the slotted screws and
replace the pulley cover.
LUBRICATION
The oil should be changed once a year in the gear box
using extreme pressure oil.
The gear box drain plug is shown at left Fig. 20 (A). The
oil fill and level plug is at the top of the gear box.
Note four raising screws Fig. 21 (B) in the outside
columns of the machine should be lubricated using a
grease.
Periodically remove screw and side cover, clean chains
and sprockets lubricate using a light machine oil.
D
B
B
E
E
D
C
A
D
D
Fig. 20
Fig. 21
Fig. 22
Fig. 23