Version 10.06.2013
ZL-MYGIG-V2-R
Pa
ge
7
Instruction for example Chrysler C300
Remove the front panel from the centre console, which is
attached to multiple clips.
Remove the 4 TORX screws and pull the device out of the
centre console.
Remove the grey female 22pin connector from the rear of
the device and connect it to harness TV-MYGIG. Connect the
grey female 22pin connector of harness TV-MYGIG to
the device.
Connect the AV-input and the AV-output to the white female
22pin connector according the pin assignment and connect the
Female RCA to the av-sources.
Note:
Use the attached white female 22pin connector if the male 22pin connector of the
head-unit isn’t occupied by a white female 22pin connector.
If the male 22pin connector of the head-unit is occupied by a white female 22pin connector
connect the pins into the white female 22pin connector of the vehicle (the attached white
female connector will not be required.
There are 2 options if the pins are occupied by factory:
1.
Factory-RSE is installed. This interface will not be needed (separate video-in-motion
TF-MYGIG optionally available).
2.
Factory RSE isn’t installed. The pins are prepared by factory and can be removed.
