Version 22.12.2011
USB-NTG25
Pa
ge
6
3.2.
Quadlock connector
Remove the Comand from the dash-board.
Disconnect female Quadlock connector from the back of the Comand.
Remove MOST®-insert from the factory harness female Quadlock connector.
Plug MOST®-insert into male MOST®-connector shell of harness C3C-MBN25.
Plug female Quadlock connector into male Quadlock socket of harness
C3C-MBN25.
Plug male MOST®-connector into female MOST®-socket of C3C-MBN25.
Plug female Quadlock connector of C3C-MBN25 into male Quadlock socket of the
Comand.
Plug female 18pin AMP connector of C3C-MBN25 into male 18pin AMP connector of
the Comand.
Note:
Vehicles without MOST®-components, which means without factory CDC, without
factory phone or other MOST®-components have no optical leads at the Comand. In this
case remove female MOST®-socket of C3C-MBN25 and the single optical lead between the
male and female Quadlock of the C3C-MBN25. Plug the now left over single optical lead on
the male Quadlock side into the now empty slot of the male MOST®-connector.
