Version 17.03.2021
RL-PCM3-2-TF
Pag
e
10
4.3.
Alternatively coding and decoding of rear-view camera and ParkAssist (e.g. if
steering-wheel buttons not existing, only PCM3.1)
Alternatively to coding by steering-wheel buttons the coding and decoding of rear-view
camera and ParkAssist can be done by DIP 5 in conjunction with DIP 3 and 4 of interface-box
RLC-M40-2.
1.
Set DIP switch “5” to OFF position
2.
Turn on ignition
3.
Wait until the head-unit has booted
4.
Set DIP “3” and DIP “4” of CAN-box (depending on the desired coding/decoding)
5.
Set DIP switch “5” for 5 sec. to ON position
6.
During configuration the red and blue LED are blinking
short inside the CAN-box (visible at the male 8pin Molex
connector). The PCM makes a reset after 5-10 sec.
7.
The red and the blue LED inside the CAN-Box are
glowing and the menu „Rear-view camera“ respectively
“ParkAssist” appears in the menu OPTION after a
successful coding (or disappears after successful
decoding)
Note:
After a coding or decoding another coding isn’t possible within the next 60 seconds!
If there are factory-PDC existing in the car you have to set DIP 4 to ON while coding. If not
the factory PDC will be decoded!
DIP
Function
ON
OFF
DIP 3
Rear-view camera
Coding
Decoding
DIP 4
ParkAssist
Coding
Decoding
DIP 5
Activation of the coding/decoding process 5 sec. = start Default setting
BACK