Version 24.02.2011
Se
it
e
12
Connect the 2pin AMP connector with
the 2pin AMP male plug of the harness
C1C-BMW0x.
Automatic switching to camera video will work from interface mode and from OEM mode.
3.2.
Vehicles with factory rear-view camera and factory TV-tuner
The factory rear-view camera is connected to the white 18pin AMP connector of the factory
TV-tuner. Video-signal on pin 1 (yellow-black), video-signal ground on pin 10 (green).
Connect video-signal and video-signal ground analogue to
3.1. Vehicles with factory rear-view camera
via the 2pin AMP.
3.3.
Connecting an after-market rear-view camera
Connect video-signal and video-signal ground of the camera analogue to
3.1. Vehicles with factory rear-view camera
via the 2pin AMP.
Automatical switching to the camera input when reverse gear is engaged is only possible in
interface mode.
3.4.
Special case – vehicles without fibre optical components (very rare)
Vehicles without fibre optical components, which means without CDC, without phone or
other fibre optical components have optical wires at the navigation computer, but it can be
possible that the ring is not connected to diagnostic connector in the glove compartment. In
this case a connector bridge for optical wires is necessary.
4.
Device control
The c.Logic lite interface for BMW has the possibility to remotely control up to 2 pre-
programmed devices. The device list in the device control table shows the pre-programmed
remote channels and the related IR-remote cables.
An IR-remote cable STA-xxx must be ordered separately for every device which shall be
controlled.
If 2 devices shall be controlled, the 3-Pin AMP Y-cable STA-Y is needed (1 connector to 2
plugs). This is connected to the 3-Pin AMP plug of the interface harness,
and gives the opportunity to connect 2 IR remote cables.
The 3-Pin AMP connector of the IR-remote cable has to be connected to the interface
harness or the Y-adapter STA-Y, the device specific side to the IR port of the related device.
