Version 20.09.2017
C2-E65-TV
Pag
e
10
2.3.2.
Installing AV-source’s IR-sensor additionally
Additionally to the control via OEM navigation, it is possible to install the original IR-sensor
of a connected device. By using the respective Y-adapter (e.g. STA-Y35MM or STA-RJ12) for
the IR-Port of the connected device, the controls of navigation AND device’s IR-sensor can be
connected and used simultaneously. Installation of the IR-sensor is recommended as the
controls via navigation are limited, and not all functions may be covered.
2.3.3.
After-market rear-view camera and rear-seat-entertainment
Using RCA-cables, connect the rear-seat-entertainment to the female RCA-connector
VIDEO OUT of MOST®-box C2C-M336.
Note:
As the output is a full output, not shared with the video signal for the
navigation system, splitting the video with an RCA Y-cable might give a good enough
picture for two rear-seat-entertainment monitors. If not, or if connecting more than
two monitors, use a video splitter.
Connect the video RCA of the after-market rear-view camera to thethe female RCA
connector R-CAM IN of MOST®-box C2C-M336. The green wire of harness C2C-
BMW02 can be used as +12V power (max 1A) supply for the rear-view camera.
Note:
Automatic switching to the camera-input when reverse gear is
engaged works only in c.LOGiC mode.
