3
•
You should check the names and colors of each wires exactly, before you connect the wires.
ex) CAN HIGH: White wires / CAN LOW: Blue wires
•
The ‘POWER / CAN Cable’ should always be connected last and be disconnected first.
•
The 'Mode Switch' is an optional part to change modes forcibly without CAN-BUS.
Generally, the CAN-BUS wires are connected for changing modes by original buttons.
•
When the reverse gear is not detected by CAN-BUS,
the 'REVERSE 12V
IN wire’ should be spliced with 12V power of reverse light.
HDMI device-related
•
HDMI mode accepts general-screen resolution of HDMI devices.
•
Generally, '5V 1A Power output(5V USB POWER)' is a standard voltage for charging smartphone.
If you need higher voltage than 5V, you should add a separate power supply.
Navigation(GPS) box-related
•
When you connect the power wires(B+, ACC) to the navigation(GPS) box,
the ‘NAVI (12V) OUT wire supported by the device
should be spliced with an ACC wire of navigation box.
•
After installation is done,
select an applicable navigation(GPS) box model in the 'Navigation model selection
menu' of setting mode.
•
The navigation box should be powered off before unplugging the HDMI cable.
Cautions
www.car-solutions.com
car-solutions.com
