SIMPLE™ KEY USER GUIDE
SIMPLE™ KEY USER GUIDE
8
9
STEP 2 (OF 2) REMOTE PAIRING
Instructions have timing requirements. If you wait too long between steps, your vehicle’s computer may time out,
requiring you to start over. Once you begin the pairing procedure, move at a quick and even pace.
NOTE:
If you have a Toyota Camry or Corolla, your vehicle may not be equipped with a remote. This key does
not add remote features that your vehicle did not have before.
1.
Find your vehicle’s make, model, year, and transponder chip type in the Compatibility Lookup on pages 4-5.
Turn the dial on the EZ Installer™ to the position listed for your vehicle’s make, model, year, and transponder
chip type under the column labeled, “Pair Remote EZ Installer™ Dial Position.”
a.
NOTE:
If more than one dial position exists for your vehicle, try the PRIMARY dial position first. If you
are unable to successfully pair the key, try the ALTERNATE dial position listed for your vehicle.
b.
NOTE:
One working key and the new key should be present during the pairing process.
2.
Enter the vehicle and ensure all doors are closed.
3.
Begin with the vehicle in PARK and the engine OFF.
4.
Remove the security label from the EZ Installer™ and insert it firmly into the on-board diagnostic (OBD) port
located under the dash.
a. The location of your vehicle’s OBD port can be found in your owner’s manual.
5.
Insert the
original key, buttons facing down,
and turn the ignition to the ON/RUN position. If there are no
markings, turn the key clockwise and stop just short of starting the engine.
a.
NOTE:
It is important to make sure that you insert the key, buttons facing down, so that when you
turn the key to the ON/RUN position, buttons are facing up and easily visible and accessible for the
following steps.
6.
To continue, press and release the EZ Installer™ button.
a. NOTE: If you hear a series of 5 quick beeps, this indicates that the maximum number of remotes have
been paired, and an error has occurred. Please see FAQs to learn more.
7.
Wait and listen for 2 quick beeps from the EZ Installer™.
8.
On the
new remote
, simultaneously press the LOCK and UNLOCK buttons. Then, press and release the
UNLOCK button.
9.
When pairing is complete, you will hear 3 quick beeps from the EZ Installer™. Depending on the model, your
vehicle may also beep twice.
a.
NOTE:
: If you do not hear beeps from the EZ Installer™ and/or your vehicle an error may have occurred
(see FAQs for more information). Repeat Step 8 again.
10. To pair additional remotes, repeat the pairing process for any additional remotes, beginning with REMOTE
PAIRING STEP 5.
TOYOTA IGNITION POSITIONS
