USER GUIDE
5
4.
Insert the key into the ignition and turn the key to the ON position. This
should be the position before starting the vehicle, see below. DO NOT start
the vehicle
5.
Remove the security label from the EZ Installer and insert it firmly into
the on-board diagnostic (OBD) port located under the dash.
a. The location of your vehicle’s OBD port can be found in the
owner’s manual.
6.
The EZ Installer will beep twice when it powers up and starts the process.
7.
The EZ Installer will sound a short tune when programming mode has
started.
a. Your vehicle may or may not provide feedback such as the door
lock cycling, a message on the dashboard, or a chime.
8.
After hearing this short tune, press and hold both Lock and Unlock on your
new remote for approximately 15 seconds.
9.
Repeat step 8 for each additional remote to be programmed.
10.
After all remotes have been added, turn the key to the Off position and
unplug the EZ Installer.
11.
Press buttons on each remote to test they were properly programmed to
the vehicle.*
*Some vehicles may need to have the engine started and stopped, and the
driver's door opened and closed before the remotes will work.
FREQUENTLY ASKED QUESTIONS
Q:
Can I use the same EZ Installer on other vehicles?
A:
No. The EZ Installer will be locked to the first vehicle it is used on. You may
add more remotes to the same vehicle again as needed, but it will not work on
different vehicles. If the EZ Installer sounds 3 beeps at 1 second intervals, and
then beeps rapidly, this signifies the device has already been used on another
vehicle. Visit CKESimpleKey.com or your local retailer to purchase additional
remotes.
GM IGNITION POSITIONS
