Version 11.03.2015
CI-TF-UCON22
Pa
ge
3
Pin-assignment of the CAN-Box TV-500 (Molex 8pin)
Cable colour
Pin-No. Assignment
●
Yellow
Pin 4
CAN-HIGH – connection to the head-unit
●
Blue
Pin 3
CAN-LOW – connection to the head-unit
●
● Yellow/Black Pin 8
CAN-HIGH – connection to the vehicle
●
● Blue/Black
Pin 7
CAN-LOW – connection to the vehicle
●
Red
Pin 1
+12V permanent
● Black
Pin 5
Ground
●
Green
Pin 6
Activation of the video-in-motion function
(+12V = TV-free activated)
●
White
Pin 2
No function
Note: Cinch plugs on the harness forward the factory camera picture and AUX signal
and must therefore remain connected.
2.
Installation
Switch off ignition and disconnect the vehicle’s battery! If according to factory rules
disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle is
sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a
resistor lead.
Note
: The interface is installed on the backside of the head unit.
3.
Activation of the video-in-motion function
The video-in-motion can be activated and deactivated by Dip 1 or alternatively by the
included loose green cable in connection with a switch (not included in delivery).
Video-in-motion permanent
With dip1 to ON the video-in-motion function is activated permanently without disturbing
the navigation performance.
Video-in-motion selective
With dip1 to OFF the included green cable is used to activate the video-in-motion function.
Connect a switch to the green cable and connect the green cable to +12V ACC.
●
+12V
= TV-Free is activated
●
0V
= TV-Free is not activated
Note
: The loose white cable is not required and must be isolated.