Version 03.08.2020
HW:
CAM(V100)/(V32)
CI-RL4-R40
P
a
g
e
16
2.7.1.
Audio insertion
This interface can only insert video signals into the factory infotainment and switch audio
signals. If an AV-source is connected to AV1 or AV2, the audio insertion has to be done by
the factory audio AUX input or a FM-modulator to which the interface’s sound-switch output
is connected. The inserted video-signal can be activated simultaneously to each audio-mode
of the factory infotainment. If 2 AV-sources shall be connected to the infotainment, for
audio switching an additional electronic part is required.
2.7.2.
After-market front camera
The red power supply output
ACC/front cam out 12V (max 3A)
can be used to power
a front camera. If Dip 1 is set to ON (of the black 8 dips), the power supply output
gives +12V (max 3A) when reverse gear is engaged incl. 10 seconds delay after
reverse gear is disengaged.
Note:
In addition, a manual switch-over to the front camera input is possible via keypad
(short press) from any image mode. The power supply output gives +12V then, too (if Dip 1 is
set to ON and the front camera input is selected).
