Version 05.01.2022
HW CAM(V100)/(V20)
CI-RL4-LR16-8/10
P
a
g
e
17
2.6.1.
Audio-insertion
This interface is only able to insert video signals into the factory infotainment. If an AV-
source is connected, the audio insertion has to be done by the factory audio AUX input or an
FM-modulator. The inserted video-signal can be activated simultaneously to each audio-
mode of the factory infotainment. If 2 AV sources shall be connected to the infotainment,
additional electronic is necessary to switch the audio signals.
2.6.1.1.
After-market front camera
For RL4-LR16-8 - Incontrol Touch with 8inch monitor:
The red power supply output
ACC/front cam out 12V (max 3A)
can be used to power a front
camera. If Dip 1 is set to ON (of the black 8 dips), the power supply output su12V
(max 3A) when the reverse gear is engaged and additionally
10 seconds delay after the reverse gear is disengaged.
Note:
In addition, a manual switch-over to the front camera input is possible via keypad
(short press) from any image mode. The power supply output su12V then, too (if Dip
1 is set to ON and the front camera input is selected).
For RL4-LR16-10 - Incontrol Touch Pro with 10.2inch monitor:
The red power supply output
ACC/front cam out 12V (max 3A)
can be used to power a front
camera.
Attention: In this case, the front camera must be suitable for permanent operation!
