Product description
Article
C1C-VW01
Function
Harness for
Multimedia Interface “
C1C-M01
”
For use in conjunction with the following systems
VW and SKODA with MFD1
AUDI with Navi Plus
Pin assignment of harness C1C-VW01
Colour/Connector
Assignment
10pin connector
Rear side of navigation unit
●
Red
+12V permanent
● Black
Ground
●
Yellow
CAN-High
●
Blue
CAN-Low
●
Green
VIDEO ON +12V (only for navigation version A or B)
3pin AMP connector
IR-port of AV-source
●
Cinch connector red
AUDIO-Input (right)
● Cinch connector black
AUDIO-Input (left)
Installation of harness with C1C-M01
Instruction for VW, Skoda with MFD1 and AUDI with Navi Plus
Switch off ignition and disconnect the vehicle’s battery! If according to factory rules
disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle in
sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a
resistor lead.
Place of installation is behind the head-unit.
1. Remove the navigation unit from the centre console.
2. Remove all connectors from the navigation unit.
(MFD I)
