Version 30.01.2013
TF-PCM31
P
age
3
Pin-assignment of the CAN-Box TV-400 (Molex 8pin)
Cable colour
Pin-No. Assignment
●
Yellow
Pin 4
CAN-HIGH – connection to the head-unit
●
Blue
Pin 3
CAN-LOW – connection to the head-unit
●
● Yellow/Black Pin 8
CAN-HIGH – connection to the vehicle
●
● Blue/Black
Pin 7
CAN-LOW – connection to the vehicle
●
Red
Pin 1
+12V permanent
● Black
Pin 5
Ground
●
Green
Pin 6
Activation of the video-in-motion function
(+12V = TV-free activated)
●
White
Pin 2
Trigger output (+12V DC 500mA)
2.
Installation
Switch off ignition and disconnect the vehicle’s battery! If according to factory rules
disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle is
sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a
resistor lead.
1. The video-in-motion interface has to be installed in the
back of the navigation unit. It is necessary to unmount
the navigation unit.
2. Remove Quadlock connector from the navigation computer
and connect it to Harness TV-NTG2.
3. Remove the both 12pin inserts from the original Quadlock
connector and connect them together with the optical leads
to the Harness TV-NTG2. Connect the TV-NTG2 to the
navigation computer.
www.eldibg.com
car audio & multimedia system