7
www.capritools.com
• Lubricate the tool before first use.
• Lubricate the tool daily as well as before and after
each use.
• Lubricate the tool before storage.
• Moisture in the air supply degrades components
and creates rust within the tool, which negatively
affects its performance. Daily lubrication is
necessary to maintain proper operation of the tool.
Failure to do so will reduce the tool’s useful life and
void the warranty.
To lubricate the tool:
1. Wear eye and ear protection.
2. Turn off the air supply, depress the trigger to release
residual air, and disconnect the air line from the
tool. Remove any sockets and attachments.
3. Face the air inlet upwards, depress the trigger, and
place 1 teaspoon of 10W air tool oil into the air
inlet.
4. Reconnect the tool to the air supply. Run the tool
for several seconds to allow the oil to circulate. Do
not point the exhaust at yourself or anyone else.
Excess oil will exit from the exhaust and should be
captured with a shop towel.
Before you begin:
• The impact wrench is designed for tightening and
loosening threaded fasteners. Use the tool only for
intended purposes.
• Drain the air tank.
• Lubricate the tool.
• Use only sockets and accessories in appropriate
sizes and ensure they fit securely.
• Use only impact sockets and impact attachments
with the tool.
• Always wear proper personal safety equipment.
• Keep yourself well balanced with proper footing at
all times.
• Keep your hands dry, clean, and free from oil and
grease.
• Use only up to 90 PSI air pressure.
Operation:
• Ensure forward/reverse is in the desired position
before starting the tool. Provide sufficient rear
clearance before loosening fasteners.
• Use the power dial to select desired power setting
(2 settings in forward and 1 setting in reverse).
• Depress the trigger to use the tool, and release the
trigger to stop.
• Keep hands and body away from moving parts.
• Lay the tool down only when it completely stops
moving.
• Turn off the air supply, depress the trigger to
release residual air, and disconnect the air line
from the tool each time before changing sockets
and attachments.
• Turn off the air supply, depress the trigger to
release residual air, and disconnect the air line
from the tool when the job is completed.
• Lubricate the tool before storage.
lubrication
Usage
