Instruction manual ZAL48CO, ZAL48SL, ZAL48BK
12
Please keep this instruction manual for future reference
S TA N DA R D C O N F I G U R AT I O N :
Standard configuration requires all cooker hood remote controls to be provided with the same
transmission code. In the event two cooker hood remote control systems are installed in the same
room or nearby, each system may affect the operation of the another. Therefore, the code of one
radio control system must be changed.
G E N E R AT I N G A N E W T R A N S M I S S I O N C O D E :
The remote control system is provided with pre-set codes. Should new codes be required, proceed
as follows: Press simultaneously buttons:
for two seconds. When LEDs light on, press buttons:
(within 5 seconds). LEDs flashing 3 times indicate the procedure is completed.
WARNING:
This operation permanently deletes the pre-set codes.
L E A R N I N G T H E N E W T R A N S M I S S I O N C O D E :
Once the transmission code is changed in the remote control unit, the electronic central unit of the
cooker hood must be made to set the new code in the following way:
Press the main power-off button of the hood and then restore power to the electronic control unit.
Within the next 15 seconds, press the Light Button
to synchronise the central unit with
the code.
R E S E T O F T H E FAC TO RY C O N F I G U R AT I O N :
To restore the Factory configuration, follow the procedure described below: press
simultaneously buttons:
for 2 seconds. When LEDs light on, press buttons
(within 5 seconds). LEDs flashing 6 times indicate the procedure is completed.
