6
1.
When open the door 90 degree, take out 2 screws (2) from lower door axis (3), remove the door
(4), then pull out the door and door axis (Fig. A).
2.
Put the door (4) safety and take out the plug (12) from top of door frame, unscrew 1 screw (11) at
bottom and remove the Door limit device (10), then install the Door limit device (10) at top of door
frame, please use spare plug (12) to block the hole at top of door frame. (Fig. A/B)
3.
Take out 3 hinge screws (6) from top hinge (right) (5) and remove it. (Fig. C)
4.
Remove decorative nail (8) from left top of cabinet and install spare top hinge (Left) (7) at left top
of cabinet with 3 screws. (Fig. D)
5.
According above procedure, install spare lower hinge (left) (9). (Fig. E)
6.
The door revolves 180 degrees, install the door with same way it was removed and fix it with door
aligned.
7.
Block the hole at right top of cabinet with spare decorative nail (8).
¾
Installing the handle
Remove the door gasket on the drilling holes side to install the handle. (see below
drawing)
Front
Back
