Setting the temperature
Each cooling compartment of the wine cooler is independently controlled. To set the temperature:
•
Connect the power cord to a properly grounded outlet. In the event of a power interruption, all
previous temperature settings are automatically erased and each compartment will default to a
preset temperature setting of: 7°C for upper compartment, 7°C for middle compartment and
12°C for lower compartment.
•
Upper and Middle compartment: Set the desired cooling temperature by pressing the buttons
adjacent to the “Set Upper/Set Middle” program. Each depression of the buttons will scroll
through the available temperature settings (for each compartment) in increments of 1 degree. The
temperature selected will flash in the LED display for approximately 5 seconds, then revert back to
display the set temperature of the cabinet.
Upper compartment: The temperature setting can be adjusted from 5°C to 18°C.
Middle compartment: The temperature setting can be adjusted from 5°C to 1
0
°C.
•
Lower compartment:
Set the desired cooling temperature by pressing the buttons adjacent to the
“UP/DOWN”
program. Each depression of the buttons will scroll through the available
temperature settings in increments of 1 degree. The temperature selected will flash in the LED
display for approximately 5 seconds, then revert back to display the set temperature of the cabinet.
The temperature setting can be adjusted from 1
0
°C to 18°C.
NOTE
:
If the unit is unplugged, if power is lost, or turned-off, you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the wine cabinet will not start.
When you use the wine cabinet for the first time or restart the wine cabinet after it has been switched
off for a long time, there could be a few degrees variance between the temperature you select and
the one indicated on the LED readout. This is normal and it is due to the length of the activation time.
Once the wine cabinet has been running for a few hours, the temperature display will re-gain
accuracy.
Internal light
In order to reduce energy consumption, the LED light within this wine cabinet will automatically
switch off after 10 minutes. If you would prefer the LED light to remain on continuously, this is
possible. Please press and hold the "LIGHT" button for 5 seconds, the display will show "LP". After
4 seconds the display will revert back to normal and the light will remain on until manually switched
off.
If you would like to revert back and conserve energy (recommended), press and hold the "LIGHT"
button for 5 seconds, the display will show "LF". After 4 seconds the display will revert back to
normal, and the light will automatically switch off after 10 minutes.
6
