15
Instruction manual WDU050
Please keep this instruction manual for future reference
G. From underneath the sink, slip the fiber gasket onto the
exposed sink flange. With arrows pointing up, screw the
support ring onto the sink flange and hand tighten until
the sink flange will not move. (NOTE: If your sink is more
than 15mm thick you will need to flip the supporting ring
so the arrows are pointing down. This will provide a greater
distance on the sink flange allowing it to be used on sinks
up to approximately 22mm thick). At this point you may
want to insert the stopper into the sink and fill with water
to check the sink flange seal and ensure there are no leaks.
H. Place the mount ring over the sink flange and hold in place
while installing the cushion mount (large side down). Make
sure the groove on the inside of the cushion mount f its
over the lip on the sink flange, similar to putting the lid on a
plastic container. Run your fingers around the entire cushion
mount with slight pressure. Do not press too hard. When
the cushion mount is properly seated, the mount ring can be
pulled downward over the cushion mount and will be free
to turn.
Hand tighten sink flange
Cushion mount detail
Groove
Botttom bead
Top
