When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then the dishwasher
reverts automatically to off-mode after the end of the programme.(If you open the door while the buzzer is sounding
you must press the on/off button to switch off the dishwasher). ,Shut off the water supply and open the door of the
dishwasher. Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while
they are still hot and more susceptible to breakage. They will also dry better.
Switch off the dishwasher
1.The buzzer of the dishwasher will sound for 8 seconds, then the dishwasher .will revert automatically to off-mode
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. This way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper basket onto
the dishes in the lower one.
If you open the door during a wash cycle , the machine will pause. The programme light will
stop flashing and the buzzer will sound every minute unless you close the door . After
you close the door ,the machine will start again after 10 seconds.
A cycle that is underway can on ly be modified if it has been running for a short time. Otherwis e, the
detergent may have already be en released, a nd the appliance may have already drained the wash water.
If this is the case , the detergent dispenser mu st be refilled (see the section entitled " Loading the
Detergent " ).
Open the door , press the menu button ,then press
+
or
-
button,
you can change the programme to the desired setting (see the sectio n entitled " Starting a
wash cycle. . ." ).
“ ” “ ”
1
2
A forgotten dish can be added any time before the detergent cup opens.
Add forgotten dishes.
Close the door
After the spray arms stop working, you can open the door
completely.
2
3
Open the door a little .
1
4
5
The dishwasher will run after 10 seconds.
Wash th e arms in soapy and warm water and u se a soft brush to
clean the jets. Replace th em after rinsing them thoroughly.
When following this procedure from step1 to step 3, the filter system will be removed;
when following it from Step 3 to Step 1, the filter system will be installed.
It is dangero us to open the do or when was hing, because the hot water may s cald you.
5
Press t he
, then pre ss
-
or
+
button cha nge the programme as follows
direction:
If a programme is selected, the display screen will show it. Press the OK button,Close the door,
the dishwasher will then start.
“ ”
“ ”
menu butt on
Auto->Intensive->Normal->ECO->Glass->6 0 Min->Rapid->Soak;
