Ensure that the water drain hose is not kinked or squashed.
The waste connection must be at a height of between 40 cm (minimum) and 100 cm (maximum) from the bottom of the dish.
The water drain hose should be fixed by a hose clip. The free end of the hose must not be immersed in water.
24
Positioning the Appliance
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly into the sink. It will be necessary to
drain excess water from hoses into a bowl or suitable container that is held outside and lower than the sink.
The following things should be checked before starting the dishwasher.
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings should be taken out from the dishwasher
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent
cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can be positioned either to the right or the
left sides to facilitate proper installation.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Syphon Connection
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it is
recommended thet the hose be disconnected and the hole plugged.
Turn water fully on before starting the dishwasher.
The safety supply hose consists of the double walls. The hose's system guarantees its intervention by blocking the flow of water in
case of the supply hose breaking and when the air space between the supply hose itself and the outer corrugated hose is full of water.
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the
room, from severe splashing.
Unscrew The safety supply hose from the faucet..
3
2
1
3
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.If the water
pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear and free
of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and damage the appliance.
The water supply to the appliance can also be connected to the house hot water line (centralized system, heating system),
as long as it does not exceed a temperature of 60 C. In this case, the wash cycle time will be shortened by about 15 minutes
and the wash efficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as those for the connection to the cold water line.
Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the minimum
consult our Service Department for advice.
1
Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
2
The appliance must be connected to the water mains using new hose-sets.
The old hose-sets should not be reused.