27
Lighting gas burner fitted
with flame failure safety
device (Dual Burner)
In order to light the burner, you must:
1 – Push and turn the knob in an anti-
clockwise (fig. 4.4) direction up to
the
position (maximum rate of
inner and outer crowns); push in and
hold the knob until the flame has
been lit.
The sparks produced by the lighter
situated inside the relative burner
will light the flame.
In the event that the local gas sup-
ply conditions makes it difficult to
light the burner in
position, try
again with the knob in
position.
If there is no mains electrical supply
connection, bring a lighted match
close to the burner.
2 – Wait for about ten seconds after the
gas burner has been lit before let-
ting go the knob (safety device acti-
vation delay).
3 – Adjust the gas valve to the desired
position.
If the burner flame should go out for
some reason, the safety valve will auto-
matically stop the gas flow.
To re-light the burner, return the knob
to the closed position
●
,
wait for at
least 1 minute
and then repeat the
lighting procedure.
Note:
To change from using the inner
crown only to using both the inner and
outer crowns together, press the control
knob down before turning it. You have
to do the same when going from using
both crowns to using just the inner
crown.
Fig. 4.4
N.B.
When the cooker is not being
used, set the gas knobs to their
●
positions and also close the gas
shut-off valve placed on the main
gas supply line.
Caution!
The cooker becomes very hot
during operation.
Keep children well out of reach.
Summary of Contents for cr9204
Page 1: ......
