5
IMPORTANT:
Do not use a silicon sealant to seal the appliance against the benchtop. This will make
it difficult to remove the cooktop from the benchtop in future, particularly if it needs to be serviced.
IMPORTANT:
z
Using a standard screwdriver, tighten the tension clamps evenly starting at the centre and moving
diagonally, until the cooktop rim is tight on the worktop.
z
Do not over fasten screws to avoid thread stripped.
z
Do not use an electric or pneumatic screw driver without an adjustable safety clutch.
Electrical Connection
z
This appliance must be installed by a qualified electrician or service agent.
z
There is no cord & plug supplied with this appliance as it is to be hardwired in.
z
It is not connected via a mains socket, it is hardwired in.
z
If the mains supply where the appliance is to be installed is different from 220...240V~ make the
connection as shown in the enclosed diagrams. (The cable must be able to withstand temperatures of
120°C). Before doing this disconnect the mains
supply. A good earth connection necessary and a switch
for disconnecting all the phases must be placed accessibly, with a minimum distance of 3 mm between
contacts.
Open terminal board cover at rear panel of appliance and connect as per below diagram for 220V – 240V
earthed single phase. Close the cover after complete electrical connection.
1. Benchtop
2. Screw
3. Bracket
4. Cooktop
5. Sealing
