Once the grill has been removed, The front door panel should also be
removed.
Open the front panel and remove the two screws (B) as illustrated above.
Press the tab (C) down and remove the front panel from its guides
Secure brackets(D) onto the top of the extractor using the fitting
screws and washer (E).Check that adjustment screw (F) is fitted.
Note: Note some units may have bracket fitted.
Ensure there is a minimum distance if 700mm between the bottom of the
extractor and Caple hob surface. (See installation guides for other hob
makes). Then fix the two mounting brackets(G) to the rear wall.
Once the two mounting brackets are in position, hook the extractor
mounting bracket (D) onto the wall mounting bracket.
Some adjustment is provided within the brackets. For forward and
backward adjustment use screw (E) and for height alignment, adjust
screws (F).
Once the adjustment is complete fully tighten all screws.
If after installation there is a gap between the rear wall and the extractor
a spacer is provided. This can be fixed to the rear of the extractor and
cut to accommodate the gap.
IMPORTANT NOTE
: After the extractor has been positioned correctly
the extractor must be fixed to the adjacent cabinets through the fixing
holes in the sides of the extractor.
All that remains is to fix the front wooden door panel to the extractor by
using the diagram below, then fix the front panel.
Installation cont.
Installation cont.
P2
P3
