27
To remove the accessories, carry out the following procedure:
• stop releasing steam and/or detergent by operating the
controls (18+19) on the handle of the work hose (1);
• rotate the accessories ring nut (20).
Now, the accessories can be detached from the appliance.
Fig. 13
Fig. 14
Fig. 15
Fig. 16
p
Connecting the accessories
The accessories can be connected directly to the handle of the work hose (1) or to the extension
tubes (5), when so required. To secure the accessories to the appliance, simply fit the male end of
one into the female end of the other and rotate the locking clasp (20)
(Fig. 11)
.
To attach the large brush (2) or triangular brush (4) to the handle on the work hose (1) or to the
extension tubes (5), first you have to attach the elbow connection (3) as described in the procedure
below:
• bring the slider (p) to the 1 ASSEMBLING position
(Fig. 13)
;
• introduce the elbow connection (3) into the triangular brush (4) or multipurpose brush (2) as
shown in Fig.14;
• rotate the elbow by 180
°
until the two arrows (brush – elbow) line up
(Fig. 15)
;
• bring the slider (p) to the 2 BLOCKING or 3 ROTATION position. In the rotation position, the
brush can be rotated in relation to the extension tubes or work hose.
When removing and collecting condensate water, place a clean terry cloth over the large brush
(2) or triangular brush (4) and then lock in position with the appropriate levers.
Failure to lock the accessories using the appropriate ring nut (20) or slider (p), can pose hazards.
Accessories may suddenly come off while operating the appliance.
