RE-ASSEMBLY OF COMPONENTS
17. Notice that there are two white buttons. See figure 3.
The WHITE buttons are START buttons. Install the one
player button on the top left-hand side of the control
panel, and the two players button on the top right-side of
the control panel.
Control Panel
Blue
Red
R e d
B l u e
Red
B l u e
R i n g s -
Figure 4: Control Panel Buttons and Switches
18. Install all buttons and retaining rings on the control panel
as shown in Figure 4. Install two red buttons to the
immediate right of each joystick, install two green
buttons to the right of the red ones, and install two blue
buttons to the right of the green ones.
19. Install the switches on the buttons as shown in figure 4.
Orient the switches so that when a button is pressed, the
plastic contact on the switch is depressed.
20. Install the joysticks on the control panel as shown in
figure 5.
Figure 5: Joystick installation
CONTROL PANEL WIRING
NOTE:
All switch wires used in this game must be wired
to the N.O. (Normally-Open) connection on the switches.
Each switch requires a ground wire on the COM.
(Common) connector and the appropriate control or
wire on the N.O. (Normally-Open) connector of the switch.
21. Reconnect the existing
connectors to the
control panel according to the chart in table 1 on
page 17.
22. Connect the
player 2 kick
buttons to the auxiliary cable harness as shown
in figure 6. Make the connections according to
the chart in table
Figure 6: Auxiliary Cable Harness
TEST
SWITCH WIRING
23. Your cabinet may already equipped with test switch
and service switch. When installing, the test
and service switch, should be mounted inside the
coin
door and on top of the cash box for easy access.
(See Table 3: for wiring detail)
NOTE:
Test switch and service switch should
be
installed for this game to access
NAOMI
test
menu system.
Figure 7:
switch mounting
Volume adjustments must be made through the
volume control knob located on the NAOMI
CONVERTER PC-
board.
24.
If you are converting a cabinet that is equipped with
Q-SOUND, you may use stereo audio
output connect to existing Q-SOUND POWER
AMPLIFIER. And set “SOUND MODE” to “Stereo”.
See “SYSTEM CONFIGURATION” for detail.
