ENG 3
The charge light comes on when
a handset is in the cradle
Battery Meter
The PMR can detect when the battery charge level gets low.
An alert tone will be heard and the RED LED indicator will flash once every 15
seconds. When this happens, put it on the handset to charge pod and check the
charge LED light.
It takes about to recharge the batteries fully if they’ve become completely run
down. New batteries can take up to 14 hours to charge fully.
◎
Battery life
The walkie-talkie units have a built-in Power Saver (PS) for maximum battery life,
but when not in use, turn the unit OFF to conserve battery power.
Remove the batteries if the units will not be used for a long period of time.
3. Operation
3.1 Turning the Unit ON/OFF
1. To Turn ON
－
Press and hold the Power button. A special “beep" sound will be
heard and the LCD Screen will display the current channel.
2. To switch OFF
－
Press and hold the Power button. A special “beep" sound will be
heard and the LCD Screen will turn blank.
3.2 Adjusting the Speaker volume
There are 8 volume levels. To adjust the speaker volume, press the UP button to
increase, or press the DOWN button to decrease. The LCD Screen will show the digital
speaker volume level during adjustment.
3.3 Receiving a Call
The unit is continuously in Receive mode when the unit is turned ON and not
transmitting. When a signal is received on the current channel, the receive signal icon
“RX” will be displayed on the LCD Screen.
3.4 Transmitting (sending)
1. Press and hold the TALK (Push to Talk) button to transmit your voice. The
transmit signal icon “TX” will display on the LCD Screen and the RED LED
indicator will light.
2. Hold the unit in a vertical position with the Mic (Microphone) 5~10 cm away from
