10
LOCATION
SETUP
GAS CONNECTION
Your gas appliance must be installed on a flat, stable surface, away from any
combustible materials or construction.
Your gas appliance comes assembled, ready for a gas connection.
1-Remove the appliance from container box and place it on any level, outdoor,
non-combustible surface.
NOTE: Do not place this appliance on grass or dirt area. This may prevent proper
safety venting.
2-Open the gas door and put the cylinder inside.
3-Unscrew the battery box as shown in Fig 5. Insert the negative electrode side of
the battery into the bottom of battery box as shown in Fig 6. Then screw the
battery box as shown in Fig 7.
Note: If the battery of the pulse electronic igniter runs out of power, please replace
with new battery.
1-Check the pressure regulator and place the tank rack next to the fire pit table as
shown in Fig. 8.
2-Unscrew the locking device on tank rack per Fig. 9-1, place cylinder on the rack
and then tighten locking device shown in Fig. 9-2 and 9-3.
3-Connect the regulator and the cylinder as shown in Fig. 10. Make sure there is no leakage
or damage (please refer to “Leak Test” on page 11 and damage checking on
page 5).
4- Disconnect the regulator and the cylinder as shown in Fig. 11.
Summary of Contents for Dashley 085-1557-8
Page 6: ...6 EXPANDED VIEW H ...
