30
GB
When using the unit
• When first using the dehumidifier, operate the unit continuously 24 hours.
• This unit is designed to operate with a working environment between 5°C and 32°C, and between 30% (RH) and 80% (RH).
• If the unit has been switched off and needs to be switched on again quickly, allow approximately three minutes for the correct operation to resume.
• Do not connect the dehumidifier to a multiple socket outlet, which is also being used for other electrical appliances.
• Select a suitable location, sure you have easy access to an electrical outlet.
• Plug the unit into a electrical socket-outlet with earth connection.
• Make sure the Water bucket is correctly fitted otherwise the unit will not operate properly.
NOTE:When the water in the bucket reaches to a certain level, please be careful to move the machine to avoid it falling down.
Removing the collected water
There are two ways to remove collected water.
1 — Use the bucket
• When the bucket is full, the Full indicator light will illuminate, the digital
display shows P2.
• Slowly pull out the bucket. Grip the left and right handles securely, and
carefully pull out straight so water does not spill. Do not put the bucket
on the floor because the bottom of the bucket is uneven. Otherwise the
bucket will fall and cause the water to spill.
• Throw away the water and replace the bucket. The bucket must be in
place and securely seated for the dehumidifier to operate.
• The machine will restore to its original state when the bucket is replaced in
its correct position.
• NOTES:
- When you remove the bucket, do not touch any parts inside of the unit.
Doing so may damage the product.
- Be sure to push the bucket gently all the way into the unit. Banging the
bucket against anything or failing to push it in securely may cause the
unit not to operate.
- When you remove the bucket, if there is some water in the unit you must
dry it.
2 — Continuous draining
• Water can be automatically emptied into a floor drain by attaching the
unit with a water hose(not included).
• Remove the rubber plug from the back drain hose outlet. Attach a drain
hose(ID=13.5mm) and lead it to the floor drain or a suitable drainage
facility(see Fig. 9).
• Make sure the hose is secure so there are no leaks.
• Direct the hose toward the drain,making sure that there are no kinks that
will stop the warter flowing.
• Place the end of the hose into the drain and make sure the end of the hose
is level or down to let the water flow smoothly. Do never let it up.
• Make sure the water hose is lower than the drain hose outlet.
• Select the desired humidity setting on the unit for continuous draining to
start.
• NOTE: When the continuous drain feature is not being used,remove the
drain hose from the outlet and attach the rubber plug back to the drain
outlet.
FIG. 5
FIG. 6
FIG. 7
FIG. 8
FIG. 9
