29
© 2021, Elon Group AB. All rights reserved.
ELECTRICAL INFORMATION
• The manufacturer’s nameplate is located on the rear panel of the unit and
contains electrical and other technical data specific to this unit.
• Make sure the unit is properly grounded. To minimize shock and fire
hazards, proper grounding is important. The power cord is equipped with
a three-prong grounding plug for protection against shock hazards.
• Your unit must be plugged into a properly grounded wall socket. If the
wall socket you intend to use is not adequately grounded or protected by
a time delay fuse or circuit breaker (the required fuse or circuit breaker
is determined by the maximum current of the unit, which is indicated on
the nameplate of the unit), have a qualified electrician install a suitable
wall socket.
• Ensure the wall socket remains accessible after the unit is installed.
• Do not use extension cords or an adapter plug with this unit.
However, if
it is necessary to use an extension cord, only use an approved
“Dehumidifier” extension cord (available at most local hardware stores).
• To avoid the possibility of personal injury, always disconnect the power
supply to the unit, before installing and/or servicing.
• All wiring must be carried out strictly in accordance with the wiring
diagram located on the middle baffle of the unit (behind of the water
bucket).
TAKE NOTE OF THE FUSE SPECIFICATIONS
• The unit’s circuit board (PCB) is fitted with a fuse to provide over-current
protection. The specifications of the fuse are printed on the circuit board,
such as: T 3.15 A / 250 V (or 350 V), etc.
NOTE: All the illustrations in the manual are for explanatory purposes only.
The actual shape of the unit you purchased may be slightly different, but
the operations and functions are the same.
NOTE ABOUT FLUORINATED GASES
• Fluorinated greenhouse gases are contained in hermetically sealed
equipment. For specific information on the type, the amount and the CO
2
equivalent in tonnes of the fluorinated greenhouse gas (on some
models), please refer to the relevant label on the unit itself.
• Installation, servicing, maintenance and repair of this unit must be
performed by a certified technician.
• Product decommissioning and recycling must be performed by a certified
technician.