Innovative Lighting Products
Followspot Operating Instructions
V 1.1 2/25/21
6
1092 West Atlanta Street, SE • Suite 600 • Marietta, GA 30060 • 888-252-5912 •
• cantousa.com
ADJUSTING THE YOKE:
This followspot is provided with a yoke balancing adjustment. The balancing point is factory set for the standard product
configuration supplied with color changer. However, should you need to adjust the balancing, please follow the procedure
here below.
Two persons, one at the front and one at the back of the followspot are needed to perform this operation
1. Mount the followspot on the tripod stand with all relevant accessories attached.
2. Using a Phillips screw driver, loosen the 3 (M5) screws on each side of the yoke.
3. Gently slide the followspot backwards or forwards to the required position.
4. Make sure the yoke is correctly aligned horizontally.
5. Tighten the 6 (M5) screws
WIRING:
Before being connected to power, please make sure that the unit is outfitted with a suitable plug. Make sure the plug conforms
to the lamp power load. Ensure the plug conforms to the relevant local safety requirement and UL electrical standards.
• Make sure the plug you are fitting withstands the lamp power load.
• This fixture must be grounded
• To perform a correct wiring, please note that the cores in this mains lead are color-coded as follows:
Ground: green+yellow – Neutral: blue - Hot: brown
In case the colors of the wires do not correspond to the color of the connection points on your plug, please proceed as follows:
• The green or green and yellow wire is ground and must be connected to the connection point marked with the
letter E or with the symbol or colored in green or in green+yellow
• The blue wire is neutral and must be connected to the connection point marked with the letter N or with the
symbol or colored in black
• The brown wire is hot and must be connected to the connection point marked with the letter L or with the
symbol or colored in red
Before you finally position this product for use, temporarily connect it to a properly fused power supply to check the lamp
works correctly.
VOLTAGE:
Before operating this unit, please refer to the product label mounted at the back of the fixture to check that you are operating
with the correct voltage.
The Tango 1500 can only be operated at 120V.
