Installation Instructions Model : Z2214
Further information Phone (03) 9761 4603 [email protected]
❷
❸
Adjust the Tap Side body to the correct height
and then tighten using a 32mm spanner or
adjustable smooth jawed shifter.
Note: Make sure that the locking nuts are fully
tightened, otherwise the side body may turn
while turning the On Off lever.
Feed the cover plate
6
, onto the tap side body,
until it is flush with the counter top surface.
Thread the retaining flange and handle
7,
onto
the cartridge, securing it firmly by hand only.
See the “Removing and replacing a handle”, on
page “12” for additional details.
4
❶
Thread the bottom brass lock nut
1
, followed by the
bottom rubber washer
2
, onto the Side body
3
, thread
section.
Repeat for the opposite side.
Insert the Side body
3
, through the tap hole cut outs in
the counter top.
Feed the top rubber washer
4
over the thread section
followed by the top brass lock nut
5
.
Continue…….
