MAPMINI
Page 23 of 28
Installation Manual
September 2021 • Rev. 1.4
USB IP CONFIGURATION TOOL
1.
If the MAPMINI controller is already powered off then proceed to step 3.
Otherwise, press and hold the SHUTDN button until the SHDN LED on the
module begins flashing rapidly then release the SHUTDN button.
2.
Wait until the MAPMINI does a complete shutdown, indicated by the SHDN LED
turning OFF (except the power LED). Unplug the power connector.
3.
Insert a FAT32 formatted USB flash drive into an available USB connector on the
MAPMINI controller.
4.
Insert the power connector into the MAPMINI controller. The unit will begin the
power up sequence which takes about 30 to 40 seconds. When complete, the
MAPMINI controller will emit a series of beeps, 1 beep, 2 beeps or 3 beeps to
indicate its provisioned mode
First Access, Webster
or
CloudACS
respectively.
5.
Remove the USB flash drive from the MAPMINI controller.
6.
Insert the flash drive into a USB port on a computer. When ready, launch
Windows Explorer or File Explorer. Access the USB drive and edit the file named
Figure 21
Insert a FAT32 formatted USB flash drive
into one of the USB ports
Important
:
Shutdown Push Button
(SHUTDN) must be used to avoid data
corruption on the MAPMINI controller
.
To retrieve current configurations, insert a
FAT32 formatted USB flash drive into one of
the USB ports.
Press shutdown button until a
beep is heard then release shutdown button.
Remove
USB flash drive and review it from a
computer.
